- Procedures to change hardware on axis camera station how to#
- Procedures to change hardware on axis camera station series#
The process is complete when the status indicator turns green.
Keep the control button pressed for 15-30 seconds until the status LED indicator flashes amber. Press and hold the control button while reconnecting power. Release the button after three seconds. While continuing to hold the button, power the device. Using a straightened paperclip or similar tool, gently press and hold the firmware revert button. After powering the camera on, pressing and holding the INITIAL SET button for about 10 seconds can reset all the parameters to the default settings. The network camera resets to factory defaults and restarts after completing the factory reset. Keep the Reset button (SW1) pressed for about 2 seconds. Press and hold the Reset button (SW1) on the board with your finger while reconnecting the power. Switch off the network camera by disconnecting the power adapter. 
If the camera is not connected to DHCP server, the default IP address is 192.168.0.80. The camera has been reset to the factory default. Press and hold the reset button for 10 seconds and then release the button. New generation models include a physical recent button, including the MicroDome Duo and MegaVideo 4K. Note that many Arecont cameras do not have a reset button and must be defaulted via software, of failing that, returned to the factory. Using a pointed object, such as a pen, press and hold the reset button for 5 seconds or until the blue LED (underneath the camera module) lights up. The unit will start up with factory default settings automatically. This will take around 20 seconds from power up, then release the reset button. The red Power LED light will flash on for 3 second first, turn off for about 15 seconds, flash on for another second and turn off again. Reconnect the power cable while continuing to hold the reset button. Press and continue to hold the Reset Button (with a sharp tipped object, like a pen.). Switch off IP device by disconnecting the power cable. Press RESET about 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port No., etc. Press RESET about 10s when the camera is powering on or rebooting.Īdvidia OEMs multiple manufacturers with different methods, including ACTi, Dahua, and Hikvision. This procedure is identical to Hikvision, the OEM of WBox IP Cameras. The unit will start up with factory default settings Keep holding the reset button depressed for around 6 seconds, release the reset button. 
While continuing to hold the reset button depressed, reconnect the power cable.
Using a suitable pointed object, press and continue to hold the Reset Button depressed. Switch off the IP camera by disconnecting the power cable. Press and hold RESET for 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port No., etc. This procedure is the same as Hikvision’s own. Press the Reset button, and hold it for 2 seconds while the device is in use. Procedures to change hardware on axis camera station series#
Exposed locations are notably less secure than others, as they allow the camera to be reset without disturbing it, which could effectively take it offline.ģxLogic has two different series with different reset methods: For ease of access, some reset buttons are located at the end of the whip or exposed on the exterior of the camera. For added security, some reset buttons may be located under the dome bubble or an access panel. There are a few common reset button locations, shown below. Where manufacturers have multiple lines/OEMs/methods, we have made notes in each section.
Procedures to change hardware on axis camera station how to#
In this article, we have listed factory default procedures for 30 manufacturers as a quick reference to help reduce this confusion and simplify the reset procedure.īelow, we list how to default each manufacturer using the physical reset button. Most of the IP cameras have a reset button, but it’s not always clear what these buttons do, where are they located, how long they need to be held pressed, what settings they actually restore, etc.
0 kommentar(er)
